Cisco vPC election course of

Fairly a foul situation. I had an influence outage after which solely certainly one of two Nexus switches got here on-line. It could not set up peer hyperlink (after all). I imagine I’ve to elect the grasp manually, however do not understand how. Sticky Grasp: FALSE however I used to be unable to seek out any command to set it TRUE at NX-OS v7.

Is there higher means carry single swap to operational mode than eradicating all member ports from vPCs?

Configuration:

vrf context keepalive
vpc area 1
  peer-keepalive vacation spot 192.168.1.2 supply 192.168.1.1 vrf keepalive

interface Vlan98
  no shutdown
  vrf member keepalive
  ip deal with 192.168.1.1/29

interface port-channel1
  description peer-link
  switchport mode trunk
  switchport trunk allowed vlan 1,12,14,30,147-149
  spanning-tree port sort community
  vpc peer-link

interface Ethernet1/1
  switchport mode trunk
  switchport trunk allowed vlan 1,12,14,30,147-149
  channel-group 1 mode lively
  no shutdown

interface Ethernet1/24
  description keepalive
  switchport entry vlan 98
  duplex full
  pace 1000
  no shutdown

interface Ethernet1/48
  switchport mode trunk
  switchport trunk allowed vlan 1,12,14,30,147-149
  channel-group 1 mode lively
  no shutdown

Standing:

present vpc

vPC area id                     : 1
Peer standing                       : peer hyperlink is down
vPC keep-alive standing             : Suspended (Vacation spot IP not reachable)
Configuration consistency standing  : failed
Per-vlan consistency standing       : success
Configuration inconsistency cause: Consistency Test Not Carried out
Kind-2 inconsistency cause       : Consistency Test Not Carried out
vPC function                          : none established
Variety of vPCs configured         : 8
Peer Gateway                      : Disabled
Twin-active excluded VLANs        : -
Sleek Consistency Test        : Disabled (on account of peer configuration)
Auto-recovery standing              : Disabled
Delay-restore standing              : Timer is off.(timeout = 30s)
Delay-restore SVI standing          : Timer is off.(timeout = 10s)
Operational Layer3 Peer-router    : Disabled

vPC Peer-link standing
---------------------------------------------------------------------
id    Port   Standing Energetic vlans
--    ----   ------ -------------------------------------------------
1     Po1    down   -

vPC standing
----------------------------------------------------------------------------
Id    Port          Standing Consistency Motive                Energetic vlans
--    ------------  ------ ----------- ------                ---------------
2     Po2           down   failed      Peer-link is down     -


present vpc function

vPC Position standing
----------------------------------------------------
vPC function                        : none established
Twin Energetic Detection Standing    : 0
vPC system-mac                  : 00:00:00:00:00:00
vPC system-priority             : 32667
vPC native system-mac            : 38:90:a5:c4:fb:f7
vPC native role-priority         : 0
vPC native config role-priority  : 32667
vPC peer system-mac             : 00:00:00:00:00:00
vPC peer role-priority          : 0
vPC peer config role-priority   : 0